- User Manual Pdf
- Audio Technica At-lp60 Manual
- Audio-technica At-lp60bk User Manual 2017
- Audio Technica At-lp60 User Manual
Initial Setup
Assembling the Turntable
The AT-LP60 requires some assembly before first use. IMPORTANT:
Audio-Technica AT-LP60XBT-BK Fully Automatic Bluetooth Belt-Drive Stereo Turntable, Black, Hi-Fidelity, Plays 33 -1/3 and 45 RPM Vinyl Records, Dust Cover, Anti-Resonance, Die-cast Aluminum Platter by Audio-Technica. The Good Despite an ultralow price, the Audio-Technica AT-LP60 turntable features a built-in phono preamplifier, a user-replaceable stylus, and fully automatic operation. It plays 7- and 12-inch. Mar 31, 2014 Folks, please refer to your instruction manual for proper belt instructions.I accidentally made a mistake and I'm fortunate that my viewers have picked up on that mistake right away! Aug 26, 2014 The only real downside to the AT-LP60 design is that you can't upgrade to a better phono cartridge; the one that it comes with is permanently installed, but the good news is the cartridge's stylus.
Do not connect the AC power cord until assembly is complete.
1. Carefully place the turntable platter on the center spindle,
making certain the platter is fully seated on the spindle.
2. While holding both ends of the red tape ribbon on the
turntable belt, carefully pull the belt over the motor pulley (Fig.
2a). (If the belt drops off, remove the turntable platter and put
the belt back on it, as described on page 7.)
3. Once the belt is seated in the pulley’s groove, carefully
remove the ribbon. Make certain the belt is not twisted.
4
Place the turntable mat on top of the turntable platter (Fig. 2b).
5. If desired, the hinged dust cover may be removed. Hold both
sides of the dust cover and pull upward gently and evenly to
detach the cover from the turntable (Fig. 2c). Keep the cover
in a safe, clean place.
6. To re-install the dust cover, guide the dust cover hinges into
the two hinge receptacles located at the back of the turntable
housing.
Setting the Pre-amp (Phono/Line) Switch
For increased flexibility of use, this turntable has an internal stereo
phono pre-amplifier. The Pre-amp Selector (Phono/Line) Switch is
located on the back of the turntable. If the stereo system you are using
has a PHONO input, set the Pre-amp Selector Switch to the “PHONO”
position. If your stereo system does not have a PHONO input, set
the Pre-amp Selector Switch to the “LINE” position and connect the
turntable’s output cables to the AUX or other high-level input on your
stereo system (described later) (Fig. 3).
PHONO
LINE
PHONO
“AUX”
Input
Jacks
Pre-amp
User Manual Pdf
Selector
Switch
Stereo System
White
Red
AC
AC
Figure 3
2b – Record mat
2c – Dust cover removal
Figure 2 – Assembling the turntable
2a – Drive belt
Red ribbon
Motor spindle
Drive belt
4